Assembly Line

How cellulose acetate is made

LEGO bricks were made of this wood-based plastic until 1963. Your eyeglass frames may still be.

stations
6
things upstream
23
raw sources
8
steps from the ground
6

The short version

Purified wood pulp or cotton is reacted with acetic acid and acetic anhydride, turning a fiber that will not melt into a plastic that will dissolve. A controlled partial reversal then gives the acetone-soluble form. From there it is spun into fiber for cigarette filters and playing cards, or mixed with plasticizer for sheets and molded parts.

  1. Fluff the purified pulp

    Special dissolving pulp, or the short linters on cotton seeds, is broken down into a purified fluffy white cellulose. Ordinary pulp reacts unevenly and spoils the product.

    Goes in
  2. Acetylate the cellulose

    Cellulose goes into acetic acid and then acetic anhydride, with sulfuric acid as a catalyst. Each repeating unit has three hydroxyl groups, and the reaction turns these into acetate groups.

  3. Partly undo the reaction

    Controlled hydrolysis takes off the sulfate and some of the acetate. The common form ends up with an acetate on about two of every three hydroxyls. George Miles found around 1903 that this makes it soluble in cheap solvents.

    Goes in
  4. Dry into flakes

    The material is recovered and dried as flake. In this form it can be stored and shipped, and later turned into fiber, film or molding powder.

  5. Dissolve and spin fiber

    Flakes dissolve in acetone to make a thick solution that is pushed through spinnerets. Warm air evaporates the solvent and leaves fine filaments, the same dry-spinning idea used for spandex.

    Goes in
  6. Or plasticize for sheet

    For eyeglass frames and molded parts, flake is mixed with plasticizers into a moldable powder or cast into film. It melts at 230 °C, lower than the fully acetylated form.

End of the lineCellulose acetate Next it goes into sunglasses, dice, shoelace and 1 more.

Worth repeating

  • Old acetate film breaks down and releases acetic acid, a decay that archivists call vinegar syndrome.
  • Camille and Henri Dreyfus did their early research on cellulose acetate from 1904 in a shed in their father's garden in Basel.
  • During the First World War, acetate dope was used to coat the fabric on airplane wings.

Back to the ground

Follow every input upstream and cellulose acetate starts as these 8 raw sources.

Everything it is made of See it on the map

Open the whole family tree

Where it goes next

Cellulose acetate feeds 4 lines directly.

Keep walking

Surprise meConnect this to something else

Sources

Cite this page: "How cellulose acetate is made." Assembly Line, 2026-11-03. https://assemblyline.org/make/cellulose-acetate

Spot a mistake on this page?